Summit Steel Manufacturing Inc

In the course of the blanking course of, machines drive a punch by way of the metallic into a die. The piece that’s minimize out during blanking is the brand new work surface. The fabric produced by blanking is normally bigger than that produced by punching, and usually undergoes different steel fabrication processes. Manufactures often punch blanks intently together to scale back waste.

Shears: NC Mechanical Shear able to handle components 10′ x 1/4″
Turret Press: 44 Station Turret, 22 Auto Index Stations.
Brake Press: High quality Bender, 50 ton, 4′ Capacity with NC back gage AMADA NC Mannequin RD-100, 100 ton, 8′ capacity with AMADA NC again gage *Additionally available, 20 ton, 6′ capability press. AMADA RD-80, AMADA RD-50, Warcom Futura a hundred ton 10′ Bed, Warcom 240 Ton 14′ Bed.
Punch Presses: from 45 to 300 ton units all with cushions, coil underwire, and straighteners.
Additional capabilities: Inserting System Minimize off Saw with Auto Bar-feed, Journeyman Band Saw, Physiotherapy Lathe Wet & Dry, Timesaver Finishing Machines, CAD/CAM.

Sliding T Bevel - This one is used to replicate any angle from 0-360*. The wood half sits on a flat side of your half, then you adjust the sliding steel half to either the angle you might be looking for or to the angle of an present half and lock it down with the knurled locking nut. You may then measure that angle with the above angle finder and replicate it.